Cup Holder Assembly - Medline MDS86825DLX3 Guide De L'utilisateur

Cup Holder Assembly

1. Make sure you have all the necessary pieces.
Cup Holder with Star Knob
2. Snap U-shaped clamp onto the tubing of your rolling walker.
(see Figure A).
Note: Be sure the clamp is positioned in such a way that
it allows the cup to sit level, NOT tilted in a direction
that might allow your drink to spill (see Figure B).
3. Remove the star-shaped knob from the cup holder, insert
holder through the opening in the clamp. Tighten the knob to
assure that the cup holder stays tightly attached
(see Figures C and D).
Figure C
Figure D
14
U-Shaped Clamp 2 Scored Rubber Sleeves
(Important: Hand Tighten Only!)
(Optional)
Note: If necessary, insert a rubber
sleeve in the clamp to better fit the
size of the tubing. Whether you use
a sleeve or not, the clamp should fit
tightly onto the tubing, otherwise the
cup holder is susceptible to slipping
and spilling your drink, which may
cause injuries.
Figure A
Figure B
Cup
Holder
MDS86825DLX3/4 (GPI171)
Revised (A): 11/26/12