Cane Holder Assembly - Medline MDS86825DLX3 Guide De L'utilisateur

Cane Holder Assembly

1. Make sure all the necessary pieces are included.
Two-Hole Clamp
with star knob
2. Affix the rotating two-hole clamp toward the top of the rolling walker, keeping in mind
the base of the cane will sit in the basket and this piece actually locks the cane into
place. Remove the star-shaped knob (thumb screw), fit the opening around the tubing
on the device, and screw the knob in tightly. The open-faced clamp should be facing
the outside, 1-2 feet above the rotating basket.
(See Figures A-D).
3. Affix the rotating basket toward the bottom of the rolling walker by removing the
starshaped knob, fitting the opening around the tubing on the device, and screwing in
the knob tightly. The basket should face to the outside as it serves as a resting place
for the base of your cane. (See Figures E-G).
4. Snap the cane into the upper piece and allow the base to rest in the rotating basket.
Adjust the basket/piece placement so that the cane is balanced and secure.
Note: 1. A n optional plastic spacer may be used between the clamp and the rolling
walker frame as needed to achieve a better fit.
2. The clamp also rotates and locks into 4 different positions depending on the
angle the cane is best suited to rest.
Figure A
Figure E
MDS86825DLX3/4 (GPI171)
Revised (A): 11/26/12
Rotating Basket
Figure B
Figure F
6 Plastic Spacers (optional)
Figure C Figure D
Figure G
15