Front Wheel Assembly - Medline MDS86825DLX3 Guide De L'utilisateur

Front Wheel Assembly

1. When inserting the front wheel, make sure the "FRONT" sticker is pointed toward
the front and away from the rolling walker (see Figure A).
2. Insert the wheel to the desired height depicted by numbered holes on the wheel
frame (set to the same number as rear wheels) (see Figure B).
3. Place a triangular hand screw into the hole. Make sure the triangular hand screw
stays outside of the rolling walker frame (see Figure B).
4. Tighten the triangular screw
(see Figure C).
5. R epeat steps 1-4 for the other front wheel.
Figure A
8
(Important: Hand Tighten Only!)
Figure B
until secure
Figure C
MDS86825DLX3/4 (GPI171)
Revised (A): 11/26/12