RIB KIT PRINCE 24V Mode D'emploi page 32

G
B
A - CONNEXIONS
POINT A -
CONTROL PANEL FEATURES
LOW
SPEED
TM1
J6
J3
J4
J1 SEC.TRANSF. Connection to secondary coil of transformer
J2 MOTOR 1 Connection MOTOR 1 (no polarity)
MOTOR 2 Connection MOTOR 2 (no polarity)
J3 AERIAL Radio Antenna
COM. Common contact (common line for all the
command and safety inputs)
PHOT. Photocells contact (NC)
K BUTT. Single pulse contact (NO)
SIGNAL Gate open state and battery state output indicator
(12Vdc 3W max)
PED. BUTT. Pedestrian opening contact (NO)
EDGE Safety strip contact (NC)
A - - 24Vdc accessories power supply
A+TEST + 24Vdc safety strip self-test power supply
A+ + 24Vdc accessories power supply
BLINKER - 24Vdc flashing light (cod. ACG7061) power
supply Pay attention to the polarity
LOCK -12Vdc electrical lock power supply (MAX 15W
12V)
J4 SW Connector for microprocessor firmware upgrade.
Do not fit any jumper into the connector.
Connector for charge card of 24Vdc battery (cod.
J5 BATTERY ACG4648)
CHARGER
Built-in radio module (model CRX), or connector
PROG
JP4 JP3
SW1
JP2
CURR CURR
J5
SENS SENS
M1 M2
JP1 JP5 JP6
J6 RADIO
J7
L1 - N
JP1
JP2
JP3
JP4
JP5
JP6
M1
M2
SW1 PROG
TM1 LOW SPEED
32
32
J1
J2
for radio receiver RIB, 24 Vdc supply
Main power supply 230 Vac 50/60 Hz (120V/60Hz
upon request)
RESET
Pay attention that the jumper is inserted!
OPEN 1 motor (M1) - 1 leaf
CLOSE 2 motors (M1 and M2) - 2 leaves
OPEN safety strip self-test DISABLED
CLOSE safety strip self-test ENABLED
Select type of motor: PRINCE or KING.
Select type of motor: PRINCE or KING.
Regulator for current sensor of motor 1
Regulator for current sensor of motor 2
Programming button
Electronic regulator for low speed on approach