table of contents
EN
1.0
general information
2.0
2.1
access panel
2.2
burner assembly
2.3
2.4
2.5
3.0
3.1
3.2
4.0
4.1
4.2
B52NG-1 glass burner
note:
The information throughout this manual is believed to be correct at the time of printing. Wolf Steel Ltd. reserves
the right to change or modify any information within this manual at any time without notice. Changes, other than
editorial are denoted by a vertical line in the margin.
WARNING:
!
which are known to the State of California to cause cancer, and chemicals including carbon
monoxide, which are known to the State of California to cause birth defects or other reproduc-
tive harm. For more information, go to www.P65Warnings.ca.gov.
1.0 general information
This glass burner assembly is approved for use in the HDX52-1 gas appliance only. It is not approved for use as a
stand alone appliance or in conjunction with any other appliance.
2.0 installation
2.1
access panel
A.
Remove the door,
refer to installation
instructions. Remove
the 8 securing screws
and lift the plate
up and out of the
appliance. Gasket
may need to be
replaced if damaged.
2.2
burner assembly
note:
Install decorative panels before burner assembly.
A.
Attach the burner assembly to the
fi rebox base with the screws supplied.
2
W415-2744 / A / 11.04.19
This product can expose you to chemicals including lead and lead compounds,
INSIDE APPLIANCE
OUTSIDE APPLIANCE
EN
2
2
2
2
3
3
4
5
5
5
6
6
7