Publicité
Les langues disponibles
Les langues disponibles
EN
Mounting
The ÉPIX™ Drive 642 has four (4) mounting points (one on each corner) with 13 mm
holes to which you can install screws and mount this product directly to almost any flat
surface, truss, or other load bearing structure in any orientation. The product may also be
installed with clamps for hanging on truss. You must supply your own clamps and make
sure the clamps are capable of supporting the weight of this product.
Mounting Guidelines
CHAUVET® recommends using the following guidelines when mounting this product:
·
Make sure to mount this product away from any flammable material as indicated
in the
Safety Notes
·
Never mount in places where rain, high humidity, extreme temperature changes,
or restricted ventilation may affect the product.
·
Before deciding on a location, always make sure there is easy access to the
product for maintenance and programming.
·
Make sure that the structure or surface onto which you are mounting the product
can support the product's weight (see the
·
When mounting the product overhead, always use a safety cable. Mount the
product securely to a rigging point, such as an elevated platform or a truss.
·
When rigging the product onto a truss, you should use a mounting clamp of
appropriate weight capacity.
·
When mounting the product on the floor, make sure that the product and cables
are away from people and vehicles.
Mounting Instructions
Mounting hardware is not included with the product.
Using Mounting Clamps:
1.
Attach the clamp to the mounting bracket.
2.
Attach a safety cable to the product's safety loop.
3.
Attach the clamp to the desired structure or surface.
4.
Attach a safety cable through the mounting points.
Using Mounting Points:
1.
Screw product in the mounting points securely
a mounting surface.
section.
5
ÉPIX™ Drive 642 QRG
Technical
Specifications).
into
Publicité
