Publicité
Les langues disponibles
Les langues disponibles
ÉPIX™ Drive 642 QRG
Product Maintenance
To maintain optimum performance and minimize wear, you should clean this product
frequently. Usage and environment are contributing factors in determining the cleaning
frequency.
As a rule, clean this product at least twice a month. Dust build-up reduces light output
performance and can cause overheating. This can lead to reduced light source life and
increased mechanical wear.
Cleaning the ÉPIX™ Drive 642:
1.
Unplug the product.
2.
Wait until the product is at room temperature.
3.
Use a vacuum (or dry compressed air) and a soft brush to remove dust
collected on the external vents and accessible internal components.
4.
Clean all external surfaces with a mild solution of non-ammonia glass cleaner or
isopropyl alcohol.
5.
Apply a solution directly to a soft, lint-free cotton cloth or a lens cleaning tissue.
Wipe any dirt or grime to the outside edge of the surface. Gently polish the surfaces
with the lint-free cotton cloth or lens cleaning tissue until they are free of haze and
lint. Always dry the external surfaces carefully after cleaning them.
Replacing the Fuse
1.
Disconnect this product from power.
2.
Using a flat-head screwdriver, unscrew the fuse holder cap from the housing.
3.
Remove the blown fuse and replace with a good fuse of the same type and
rating.
4.
Screw the fuse holder cap back into place and reconnect the power.
10
EN
Publicité
