Napoleon NZ64 Instructions D'installation

NOTE: Consideration should be made for blower location as the closer to
the appliance, the greater the air fl ow noise will be.
We recommend installing the blower in a different room or even different level of the
house. This will generate greater air movement and improve the distribution of the
warm air coming from the appliance.
NOTE: Appliance may not appear exactly as illustrated. NZ6000
illustrated
This appliance is supplied with a pressure switch and a
thermally activated switch. Ensure that the pressure switch
actuating arm protrudes through the faceplate when installed.
The blower will only operate when the doors are fully closed.
1. Wire harness installation
• Remove the lock washer and nut that secure the blower to the
blower housing. Remove the blower from the housing by lifting
up and out.
• Connect the wire harness to the left side of the blower.
• Loosen the nut that secures the junction box to the blower
housing. Remove the junction box.
• Guide the end of the wire harness through the bushing in the
junction box and then through the junction box plate.
• Re-install the junction box.
• Re-install the blower.
2. Remove the template and position the blower to an inside or
outside wall into a framed opening 12
Wolf Steel Ltd., 24 Napoleon Rd., Barrie, ON L4M 0G8 Canada •
INSTALLATION INSTRUCTIONS FOR
NZ64 & NZ150-KT
NZ3000 / NZ3000H-1 / NZ6000
JUNCTION BOX
COVER PLATE
JUNCTION BOX
BLOWER
Additional
sections of liner
available from
your Napoleon
dealer.
3
/ " wide by 10
8
The blower housing should be installed onto a level surface
large enough to support the blower assembly. Allow for fi nishing
material when securing the blower housing, as the grill mounts
to the housing. Ensure the blower is oriented properly with the
footings of the blower housing at the bottom.
10.25"
E R
O W
G
I N
B L
U S
H O
3. Connect the 6" collar to the blower conection opening located
on the right and/or left side, closest to the back of the unit.
The opening that is not being used should be covered, if not
already, with the cover plate that is provided.
Secure the collar by reaching through and
bending the tabs. Use sealant to ensure that
the connection is air tight.
1
/ " high.
2
1.25"
14.25"
10.75"
12.25"
G :
IN L Y
R N E R
O N
W A O W
B L N :
T IO N T
E C M E L A
N N S E D E
C O T IS N
IE
E R IO E R
E X
G : A V F L T
N N E N
A IR U F
IN C O E M
R N N S O
U L
W A T IO
S E
U S
L Y
M B :
O N N T
C O
M E
T
S E A N
T IS U R
T
E R M B E N
A V A V C O
E M
U L
A IR A A IR
S E S E
JUNCTION
BOX COVERS
1(866)820-8686 • www.napoleon.com
10.75"
Footings
W415-0882 / C / 02.14.20