Bassinet Assembly - UPPAbaby VISTA Mode D'emploi

STROLLER ASSEMBLY
ATTACHING/REMOVING THE SEAT
To Attach Seat: Lower seat onto frame in forward or reverse position
and press down until it clicks into place. Pull up on seat to ensure it is
locked to frame.
ATTACHING/REMOVING THE BUMPER BAR
STEP 1: Insert metal posts into bumper bar
attachment slots found on both sides of seat.
CANOPY INSTALLATION
STEP 1: Pull canopy fabric over seat back recline button.
8
To Remove Seat: Simultaneously
push down release buttons
and lift seat from frame
STEP 2: To remove, press button at bottom of plastic
housing and lift bumper bar out .
STEP 2: Snap each side of canopy attachment to
seat frame.
.
STEP 1: Remove mattress.
STEP 3: Pull bassinet canopy handle upright until an
audible "click" is heard.

BASSINET ASSEMBLY

SETTING UP THE BASSINET
STEP 2: Pull both steel braces firmly towards the outer
ends of the bassinet into their respective sockets.
Make sure both braces are properly locked in place.
STEP 4: Zip bassinet cover onto bassinet frame.
9