Piggyback Assembly; Piggyback Operation - UPPAbaby PiggyBack Mode D'emploi

PIGGYBACK ASSEMBLY

PIGGYBACK SET-UP
Attaching Clamshell Mounts: Position clamshell mount under interior wheel hub and squeeze shut until
an audible "click" is heard. Repeat on other side.
NOTE: Tab should face back of stroller for easier removal.
ATTACHING PIGGYBACK TO CRUZ/ALTA FRAME
3
Attaching Latch: Unsnap button on back of
stroller basket to expose aluminum bar. Snap
latch over aluminum bar and rotate down.
Re-snap basket over center opening of latch.
NOTE: Select appropriate latch based on your
stroller manufacture date.
1: Latch for CRUZ/ALTA 2014 or Earlier
2: Latch forCRUZ/ALTA 2015 or Later
Attaching Piggyback: With Piggyback attachments
facing up, place over clamshell mounts and slide
down into place until an audible "click" is heard on
both sides.

PIGGYBACK OPERATION

USING/STORING PIGGYBACK
To Store: Lift board up and snap into latch.
REMOVING PIGGYBACK FROM CRUZ/ALTA FRAME
STEP 1: With the board in the down position, pull
Piggback attachment out and slide up to release.
Repeat on opposite side.
STEP 3: Push tab out to release clamshell mount from wheel hub. Repeat on other side.
To Move into Active Riding: Press latch down with
hand or foot to release Piggyback.
STEP 2: Rotate latch up and remove from aluminum bar.
4