ETNA T267 Notice D'utilisation page 69

B Timer with the option to turn off the cooking zone
The switch-off timer facilitates the cooking process by allowing
you to set the cooking time for a particular cooking zone. In order
to set the switch-off timer, the power level must already have
been set (see section "Turning on the cooking zones").
• Press the timer sensor key (D) to activate the timer. "00" is
displayed on the timer display (L) and the decimal point (F1)
is lit. When the (D) sensor key is pressed again, the (K) point
indicating the selected cooking zone, starts fl ashing.
• As long as the decimal point is lit, sensor keys "+" (G) and
"–" (I) can be used to set the time in the range from 1 to 99
minutes. IF the sensor key is pressed and held, the rate at
which the timer setting is changing will be increased after a
while.
• When the value was set, the countdown starts. The
corresponding point (K) is still fl ashing, indicating the selected
cooking fi eld.
Cooking time can be set for each cooking zone
independently. If several timers have been
programmed, the time that is closest to zero will
always be displayed. This is indicated by a fl ashing
signal light (K) which indicates the cooking fi eld.
Changing the timer setting
• Timer setting can be changed any time during operation.
• Press the timer sensor key (D) to display the remaining time
for the selected cooking fi eld. The corresponding signal light
(K) will fl ash.
• Press the "+" (G) or "–" (I) sensor key to set the new cooking
time.
Checking the remaining cooking time
If several timers are set, the remaining cooking time can be
displayed by touching the (D) sensor key.
Switching off the timer
After the set time has elapsed, an alarm will sound and the
cooking zone will be turned off. The value "00" fl ashes on the
timer display. Switch off the alarm by pressing any sensor key; if
this is not done, the alarm will go off after a certain period of time.
69