Olsberg ASTRAL 14/69 3 Serie Notice D'utilisation page 26

•
Push the inside front panel firmly against the
heater core and fix to the inner housing using the
screws above and on the side.
fig.22
•
Now fix the heater to the wall using the screws
through the heater rear panel left and right.
fig.23
•
Remove the tape holding the plastic cover plate of
the adjustment knobs on the upper right side of the
heater rear panel. Lift the cover plate.
•
Check that the air-mixing plate is functioning cor-
rectly (only heaters 14/692, 14/693, 14/694,
14/695, 14/696 and 14/70). To do this, turn the
output regulator knob from full left (CLOSED,
fig.24) to full right (OPEN, fig.25) and back.
26
fig.24
fig.25
•
Close the heater (fig.26):
Firmly fix the side panels to the upper right and left
side inner cabinet using the screws.
Set the front panel on the upper lip of the heater
rear panel in such a way that the tabs in the front
panel fit into the slots in the rear panel.
Tilt the front panel downwards so that the fixing
brackets on the lower left and right hand sides of
the front panel fit between the inner cabinet and
the side panels.
Please ensure, that between front and side
panels the circumferrending gap has a con-
stant width! The inside of the front panel is
then closely attached to the edges of the side
panels!
Secure the fixing screws.
Replace the plastic covering caps.