Description; Operation - Dustcontrol DC 5800c Manuel D'instruction

Description

The DC 5800c 5 kW is anelectric powered vacuum
extractor for use on source extraction, cleaning and
material transportation applications in most types of
industries.
The extraction system functions with negative pres-
sure (vacuum) that draws the air through suction
casings/nozzles, hose system, separator and fi lter
system. Coarse separation of dust occurs in the units

Operation

Connect the machine to a suitable power source
according to the specifi cations found on the identi-
fi cation label on the machine. If an extension cord is
to be used with the unit, it should be suitably rated
according to the prevailing electrical code and be at
least water resistant. Check rotation of the motor at
startup. On machines equipped with a phase reverser,
incorrect rotation can be easily changed. Machines
not equipped with a phase reverser will require the
service of a qualifi ed electrician to interchange two
phases in the power supply.
The fi lter should be cleaned 1-2 times per day with
continuous running or if the machine is equipped with
a fi lter monitor, when this is in the red area.
For fi lter cleaning:
1. Start the machine.
2. Close the shutter valve on the machines inlet.
3. With slow, even motion open the pulse top by
cyclone which is a highly effi cient separator for larger
particulate. The fi ne dust is separated and contained
by the units fi lter system. Separated material is col-
lected for disposal in the plastic sack or container at
the base of the cyclone.
Filter cleaning with reverse pulse gives long fi lter
life and constant capacity.
lifting the handle. Repeat three to six times.
4. Open the shutter valve.
5. If the fi lter condition meter reads green work
can continue, if in the red, pulse clean again. If
after several repetitions, the fi lter condition still
shows red the fi ne fi lter must be changed.
The plastic sack should be changed only after the
fi lter has been cleaned. The sack should be changed
when the dust level is about 5 cm under the foot valve.
The plastic sack should be sealed after removal from
the machine.
Use only original plastic sacks.
DC 5800c 5 kW - 9
Art nr 9090