Reversing The Access Door - Hatco FLAV-R-SAVOR FSHC-12W1 Manuel D'installation Et D'utilisation

English
NOTE: To prevent delay in obtaining warranty coverage,
complete online warranty registration. See the
ImpORTaNT OWNER INFORmaTION section for
details.
3. Remove tape and protective packaging from all surfaces of
the unit.
NOTE: Refer to the OpTIONS aND aCCESSORIES section in
this manual for options and accessories instructions.
4. Install the 5" (127 mm) casters onto the bottom of the cabinet.
NOTICE
Do not lay unit on side with control panel or damage to unit
could occur. Make sure all water is drained prior to laying
unit on its side.
a. Remove all shelf supports, tray slides, heat tunnel, and
water pan.
b. Carefully lay the unit on its back side. This step requires
two people.
NOTE: Place a piece of cardboard between the cabinet and the
floor to prevent marring the cabinet finish.
c. Install the two swivel casters to the front of the unit using
four mounting screws (provided). Tighten securely.
d. Install the two stationary casters to the back of the unit
using four mounting screws (provided). Tighten securely.
e. Return the unit to its upright position. This step requires
two people.
5. Install the heat tunnel and water pan.
6. Unpack the adjustable tray slides from the box and install
them inside the cabinet. There are 12 or 17 adjustable tray
slides for each side of the cabinet. Four shelf supports, two
on each side of the cabinet, support the tray slides.
To install each tray slide:
a. align the hooks at each end of the tray slide with the
desired slots on the front and rear shelf supports.
b. angle the tray slide hooks into the slots and let the tray
slide rotate down into position.
7. place the unit in the desired location.
• Locate the unit in an area where the ambient air
temperature is constant and a minimum of 70°F (21°C).
avoid areas that may be subject to active air movements
or currents (i.e., near exhaust fans/hoods and air
conditioning ducts).
• make sure the unit is located on solid, level flooring.
• make sure the unit is at the proper height in an area
convenient for use.
Form No. FSHC1217Wm-0515

Reversing the Access Door

The access door is field reversible to allow it to be hinged on
either the right or left side. Use the following procedure to
reverse the door.
1. Remove the four handle screws securing the handle to the
door. Remove the handle.
2. Slide the hinge covers off of the door hinges.
3. at each door hinge, remove the three hinge screws that
secure the hinges to the cabinet frame. Remove the access
door.
NOTE: The hinges remain mounted to the access door.
4. Transfer the screw plugs from the hinge screw holes on
the opposite side of the cabinet to the open holes where
the hinges were just removed.
5. Remove the two strike plate screws that secure the strike
plate to the cabinet.
6. Transfer the screw plugs from the strike plate holes on the
opposite side of the cabinet to the open holes where the
strike plate was just removed.
7. Install the strike plate on the opposite side of the cabinet
using the original hardware.
8. Rotate the door 180° and install on the opposite side of
cabinet using the original hardware.
9. Install the handle to the door in the upright position using
the original hardware.
10. Slide the hinge covers back into place on the door hinges.
Screws
Hinge
Cover
Reversing the access Door
9
INSTALLATION
Hinge
Handle
Strike
Plate