Maintenance; General; Daily Cleaning - Hatco FLAV-R-SAVOR FSHC-12W1 Manuel D'installation Et D'utilisation

MAINTENANCE

General

Hatco Flav-R-Savor Tall Humidified Holding Cabinets are
®
designed for maximum durability and performance with
minimum maintenance.
WARNING
ELECTRIC SHOCK HAzARD:
• Turn OFF power switch, unplug power cord, and allow
unit to cool before performing any cleaning,
adjustments, or maintenance.
• DO NOT submerge or saturate with water. Unit is not
waterproof. Do not operate if unit has been submerged
or saturated with water.
• Unit is not weatherproof. Locate unit indoors where
ambient air temperature is a minimum of 70°F (21°C).
• This unit is not "jet-proof" construction. Do not use jet-
clean spray to clean this unit.
• Do not steam clean or use excessive water on unit.
• Do not clean unit when it is energized or hot.
• This unit must be serviced by qualified personnel only.
Service by unqualified personnel may lead to electric
shock or burn.
This unit has no "user-serviceable" parts. If service is
required on this unit, contact an Authorized Hatco Service
Agent or contact the Hatco Service Department at
800-558-0607 or 414-671-6350; fax 800-690-2966; or
International fax 414-671-3976.
NOTE: The internal blower motor is permanently lubricated and
requires no maintenance.

Daily Cleaning

To preserve the finish of the unit as well as maintain
performance, it is recommended that the unit be cleaned daily.
Use non-abrasive cleaners and cloths only. Abrasive
cleaners and cloths could scratch finish of unit, marring its
appearance and making it susceptible to soil accumulation.
Clean unit daily to avoid malfunctions and maintain
sanitary operation.
1. move the pOWER ON/OFF (I/O) switch to the OFF (O)
position and unplug the power cord. allow the unit to cool.
2. Remove and wash all food pans.
3. Wipe down all the interior and the exterior surfaces using
a clean, damp cloth. Stubborn stains may be removed with
a good non-abrasive cleaner. Hard to reach areas should
be cleaned with a small brush and mild soap.
4. Wipe dry with a clean, non-abrasive cloth.
5. Clean the Lexan
®
water solution and a non-abrasive, damp cloth. NOTICE:
DO NOT use paper towel or glass cleaner.
6. Drain and clean
"Cleaning/Draining the Water pan" procedure in this section.
12
English
NOTICE
polycarbonate doors with mild, soapy
the water pan. Refer
Form No. FSHC1217Wm-0515
to the