Reversing The Access Door - Hatco Flav-R-Savor FSHC-5W Série Manuel D'installation Et D'utilisation

INSTALLATION
6. Place the reservoir cover over the built-in water reservoir.
7. Place the unit in the desired location.
• Locate the unit in an area where the ambient air
temperature is constant and a minimum of 70°F
(21°C). Avoid areas that may be subject to active air
movements or currents (i.e., near exhaust fans/hoods
and air conditioning ducts).
• Make sure the unit is located on solid, level flooring.
• Make sure the unit is at the proper height in an area
convenient for use.

Reversing the Access Door

The access door is field reversible to allow it to be hinged on
either the right or left side. Use the following procedure to
reverse the door.
1. Remove the four handle screws securing the handle to the
door. Remove the handle.
2. Slide the hinge covers off of the door hinges.
3. At each door hinge, remove the three hinge screws that
secure the hinges to the cabinet frame. Remove the
access door.
NOTE: The hinges remain mounted to the access door.
4. Transfer the screw plugs from the hinge screw holes on
the opposite side of the cabinet to the open holes where
the hinges were just removed.
Hinge Screw
Hinge Cover
Access Door
Removing the Access Door (FSHC-7W1-EE shown)
Strike Plate
Strike Plate Screw
Handle Screw
8
5. Remove the two strike plate screws that secure the strike
plate to the cabinet.
6. Transfer the screw plugs from the strike plate holes on the
opposite side of the cabinet to the open holes where the
strike plate was just removed.
7. Install the strike plate on the opposite side of the cabinet
using the original hardware.
8. Rotate the door 180° and install on the opposite side of
cabinet using the original hardware.
9. Install the handle to the door in the upright position using
the original hardware.
10. Slide the hinge covers back into place on the door hinges.
Hinge screw plugs
moved to these holes
(top and bottom).
Reversing and Installing the Access Door (FSHC-7W1-EE shown)
English
Strike plate screw plugs
moved to these holes.
Form No. FSHC7WM-1119