Publicité
Les langues disponibles
Les langues disponibles
1.
Machine applications
1.1 Surface type
Daily or weekly cleaning on water-proof surfaces.
1.2 Cleaning agent
Floor cleaner, degreaser, maintenance cleaner, scented
cleaner depending degree of dirt on surface.
Maximum water and cleaning agent temperature
60°Celsius.
1.3 Brush / Pad
Nylon brushes or driving discs (optional accessory).
2.
Advatages
Easy to use scrubber dryer
●
Large clean and waste water tank
●
Manual control of cleaning solution quantity
●
Comfortable push bar handle
●
Pushbar adjustable in height and in angle
●
Brushes can easily be changed to pads for intensive
●
cleaning
Squeegee can be lifted for scrubbing cleaning agent
●
for pre-cleaning of very dirty surfaces
Unit can easily be moved over stairs and is very light
●
for transportation (only 22 kg)
3.
Preparations for work / Operation
Depending of cleaning work to be undertaken choose either
Brushes or Pads.
8
A
B
15
7
5
6
English 8
RA 300 E - English
☞ Adjust the pushbar to the
best position that allows
you comfortable operation.
☞ Fill clean water tank with
water and the cleaning
agent
required
for
specific task. (Dilution rates
are marked on the label of
the cleaning agent).
☞ Make sure that the tank
cover (8) is positioned cor-
rectly! Place the clean water
suction hose (15) to the far
side of the tank and make
sure the hose is not bent.
Place the tank cover to the
rear rim for the tank cover
(A) and press the tank
cover seal (B) gently into
the front rim.
☞ Unwind the electrical cable
and plug-in the socket.
Now switch-on the vacu-
uming switch (5), brush
drive (6) and lever for
spraying solution (7).
By pushing the machine forwards and backwards the
☞
surface is cleaned and the dirty water is vacuumed
into the tank.
Should the floor be very dirty switch-off the
☞
vacuuming motor (5). Lift the squeegee by the lever
(19) and add the cleaning agent by pulling the lever for
water solution. Scrubb the floor thoroughly. Finally
switch-on the vacuuming motor switch (5), let the
squeegee (19)to the floor and vacuum the dirty
solution.
Only clean waterproof surfaces!
4.
Working with external accessories
18
16
X
Y
accessory to the other end of the spray and suction hose.
5
6
the
C
5.
Emptying and cleaning the machine after use
12
Z
Y
X
Remove suction hose (16)
☞
from the cover and attach the
suction hose of the external
accessory (X) to the cover.
Remove spraying hose (18) from
the coupling and attach the
nipple of the spraying hose of
the external accessory (Y) to the
coupling.
Attach
required
To switch on the spray-
☞
ing pump press the 3-way
tumbler switch (6) in position
"I".
Switch-on
the
tumbler
switch (ON/OFF) (5).
☞ Cleaning procedure:
Place the accessory on the
surface to be cleaned and pull
the lever of the valve (C). The
cleaning solution is sprayed
onto the surface. Pull accessory
slowly over the surface.
The vacuuming power can
☞
be regulated by turning the ring
on the suction hose (Z).
☞ Remove tank cover from the
tank and let it down behind the
machine.
☞ Lift tank by the grip and
carry to the closest drain. Re-
move cover for waste water dis-
charge (12) and empty the waste
water. Remove membrane tank by
pulling the tab of the mem-
brane tank upwards gently.
9
Publicité
