LIVARNO home 366591 2101 Mode D'emploi page 16

Safety
To avoid danger to life
from electric shock
Before connecting it to the mains, always check
the light, the power cable as well as the con-
necting cable if need be for any damage.
Never use the light if you see any damage.
Damaged power cables and connecting cables
are a danger to life as you could suffer an
electric shock.
Before assembly, ensure that the mains voltage
available corresponds to the operating voltage
necessary of the light (see "Technical data").
Never let the lamp come into contact with
water or other liquids.
Never open or insert anything into electrical
fittings or equipment. Doing this sort of thing can
lead to a serious danger to life from electric
shock.
Touch only the insulated part of the plug when
connecting to or disconnecting from the mains
supply.
The light's illuminant is not replaceable. The en-
tire light needs to be replaced if the illuminant
reaches the end of its service life.
If the external flexible cable of this lamp is
damaged, it may only be replaced by a special
cable or a cable that is only available from the
manufacturer or his service representative.
Only connect the under-cabinet light to the
mains current using the original power cable.
Only connect original under-cabinet lights of
the same type (Model 14156804L /
14156806L) with each other. Only use the
original connecting cable supplied to do so.
Connect the under-cabinet lights that are linked
up together to one socket only. Make sure that
you only connect a maximum of 10 linked-up
under-cabinet lights of the same type to one
socket. Otherwise this might overload the
connections and cables.
Please ensure all under-cupboard lamps have
been connected with the connection lead before
connecting the mains plug to the mains socket.
16 GB/IE
This product contains a light source of energy
efficiency class "E" (according to Regulation
(EU) 2019/2015).
Prevent fire and injury
hazards
RISK OF INJURY!
Immediately after unpacking check each
light and the lamp glass for damage. Do not
operate the lamp with defective bulbs and/or
defective lamp glass. In this case, contact
the service centre for a replacement.
RISK OF BURNS!
To prevent burns, be sure the light is switched
off and has cooled down before touching it.
The illuminants become very hot.
This product does not contain any parts that
can be serviced by the user.
Do not look into the LED from a close distance
during operation. Do not look at the LED with
an optical instrument (e.g. magnifying glass).
Do not operate this light with a dim-
mer or an electronic switch. It is not
suitable for this mode of operation.
Working safely
Fit the light in such a way to ensure it is
protected from damp and dirt.
Make careful preparations for the assembly
and take sufficient time. Clearly lay out all com-
ponents and any additional tools or materials
that might be required so that they are readily
to hand.
Remain alert at all times and always watch
what you are doing. Always proceed with
caution and do not assemble the lamp if you
cannot concentrate or feel unwell.