GYS FLASH 9.24 Mode D'emploi page 7

Connection / disconnection :
• Ensure that the charger is not connected to the mains before
connecting or disconnecting clamps to the battery terminals
• Always ensure the Red clamp is connected to the «+» battery
terminal first. If it is necessary to connect the black clamp to the
vehicle chassis, make sure it is a safe distance from the battery and
the fuel line. The charger must then be plugged into the mains.
• After charging, disconnect the charger from the mains, then
disconnect the negative clamp from the body of the car and then
disconnect the positive clamp from the battery, in this order.
Connection :
• Class II device
• The connection to the power supply must be carried out in
compliance with national standards.
Maintenance:
• If the power supply cable is damaged, it must be replaced by the
manufacturer, its service agent or an equally qualified person.
• Maintenance should only be carried out by a qualified person.
• Warning ! Always disconnect from the mains before performing
maintenance on the device.
• Do not use solvents or any agressive cleaning products.
• Clean the device's surfaces with a dry cloth.
Regulations :
• The Machine is compliant with European directives.
• The declaration of conformity is available on our website.
• EAEC Conformity marking (Eurasian Economic Community).
• Equipment in compliance with British requirements. The British
Declaration of Conformity is available on our website (see home
page).
• Equipment in conformity with Moroccan standards.
• The declaration C‫( م‬CMIM) of conformity is available on our
website (see cover page).
Waste management:
• This product should be disposed of at an appropriate recycling
facility. Do not throw away in a household bin.
GENERAL DESCRIPTION
Your Gysflash is ideal to charge most lead-acid batteries, often used for cars and many other vehicles. The GYSFLASH can be used safely
for : GEL (gel electrolyte), AGM (Absorbant Glass Mat), EFB ( Enhanced Flooded Battery)WET, MF (Maintenance Free), CA (Calcium)...
The Gysflash 9.24 is designed to charge :
- 6V batteries (3*2V elements) from 18Ah to 220Ah and yo to 300Ah for maintenance charge,
- 12V batteries (6*2V elements) from 18Ah to 220Ah and up to 300Ah for maintenance charge,
- 24V batteries (12*2V elements) from 15Ah to 125Ah and up to 170Ah for maintenance charge.
GYSFLASH 9.24
EN
7 7