EQUATION YAA02E-9U Notice D'utilisation page 28

INDOOR USE ONLY!
How to use
- Plug the appliance to a 220-240V ~ 50Hz socket
- Unplug the product when it's not in use.
This heater is equipped with Electronic Digital Controls that provide the ability
to set the temperature to the exact degree desired .To operate , simply follow
these instructions.
NOTE:The temperature display will not reflect the accurate room
temperature until the heater has been operating for at least 20 minutes.
1. Turn on Power Switch, Press the power button once to start the heater on
High Power(
continuously on High Power and will not shut off until the unit is
manually turned off or the room temperature over 30℃.
2. Press the power button again to change to Lower Power (
Run. If left at this setting, the unit will run continuously on Lower Power
and will not shut off until the unit is manually turned off or the room
temperature over 30℃.
3. Press the power button a third time to turn the heater OFF.
Note:the heater will run continuously if not setting temperature.
Note: if operated at the Low setting, the heater will not provide as much heat
output as in the High setting , however , the Low setting will not require a
much electrical current to operate .To avoid overloading a circuit , do not plug
the heater into a circuit that already has other appliances working.
SET TEMPERATURE
), Continuous Run. If left at this setting , the unit will run
POWER
28
), Continuous