gala gar D-GPS Manuel Technique D'instructions page 12

3.1. NUMERIC ASSIGNMENT OF PERIPHERAL CONTROLS.
Once connected the wire feeder to power source unit, we must configure the rank control which will define
the driver performance.
Whenever we connect the remote control to power source, this one will assign automatically a numeric
code to the different control units. When turn-on the equipment will take place the automatic allocation of the
numbers of work centers being the power source the center 000 and other centers ordered in an increasing
way 001 002 003 ... Assigning the remote control to the greater number available.
CONTROL UNIT
Power source
Wire feed unit D-GPS
Remote control.
See section 3.4.8.3. SETUP 3rd level parameters - Instruction Manual GPS 4000.
If necessary, we can rename the work centers to facilitate the center management or settle possible
problems of numerical duplicity during the allocation.
Press and hold to
enter
D-GPS.Wire Feeder
CENTER ASSIGNMENT
CON 000
CON 001
R-C 002
UNIVERSAL
CONTROL
Press and hold to
save
NOTES
In compact power sources, CEN - CON will
have the same designation.
When the installation is recognized it is assigned
the same designation to CEN - CON.
It prevails over the machine and wire feeder
controls.
Intermittent
With encorder
reassigned center
12