Electrolux GA60KV Notice D'utilisation page 25

Masquer les pouces Voir aussi pour GA60KV:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

11.1 The product number code
(PNC)
If you contact an Authorised Service
Centre, you need to provide the product
number code of your appliance.
The PNC can be found on the rating
plate on the appliance door. You can
also check the PNC on the control panel.
Before checking the PNC, make sure the
appliance is in the programme selection.
11.2 The washing and drying results are not satisfactory
Problem
Poor washing results.
Poor drying results.
There are whitish streaks or
bluish layers on glasses and
dishes.
There are stains and dry wa‐
ter drops on glasses and
dishes.
The interior of the appliance
is wet.
Unusual foam during wash‐
ing.
1. Press and hold simultaneously
and
The display shows the PNC of your
appliance.
2. To exit the PNC presentation, press
and hold simultaneously
for about 3 seconds.
The appliance returns to the programme
selection.
Possible cause and solution
• Refer to "Daily use", "Hints and tips" and the
basket loading leaflet.
• Use more intensive washing programme.
• Activate the ExtraPower option to improve the
washing results of a selected programme.
• Clean spray arm jets and filter. Refer to "Care and
Cleaning".
• Tableware was left for too long inside the closed
appliance. Activate AirDry to set the automatic
opening of the door and to improve the drying per‐
formance.
• There is no rinse aid or the dosage of rinse aid is
not sufficient. Fill the rinse aid dispenser or set the
level of rinse aid to a higher level.
• The quality of the rinse aid can be the cause.
• We recommend to use rinse aid always, even in
combination with multi-tablets.
• Plastic items may need to be towel dried.
• The programme does not have the drying phase.
Refer to "Programmes overview".
• The released quantity of rinse aid is too high. Ad‐
just the rinse aid level to a lower level.
• The quantity of detergent is too high.
• The released quantity of rinse aid is not sufficient.
Adjust the rinse aid level to a higher level.
• The quality of the rinse aid can be the cause.
• This is not a defect of the appliance. Humid air con‐
densates on the appliance walls.
• Use the detergent designed specifically for dish‐
washers.
• There is a leak in the rinse aid dispenser. Contact
an Authorised Service Centre.
ENGLISH
for about 3 seconds.
and
25

Publicité

Table des Matières
loading

Table des Matières