Disposal And Legal Information; Problems With The Device; Disposal & Legislation; Environmental Protection & Disposal Of The Device - Gloria 405T Mode D'emploi

7.2 Maintenance >>
NOTE!
Observe the national regulations concerning occupational safety which apply to the place of
operation as well as the applicable national regulations for operations. An expert inspection must
be performed – ideally by the maintenance service of the manufacturer – to establish whether
hazard-free operation remains possible. This should be performed in the event of defects that
may impair safety in particular, and must be performed at least every 5 years in any case.
Only use original GLORIA spare parts for repairs.
(see GLORIA spare parts shop https://shop.gloriagarten.de).
Repairs must only be carried out by a GLORIA service point.
It is forbidden to perform repair work on the container (such as welding and soldering).
Further accessories can be found at www.gloriagarten.de
7.3 Storage >>
figure
CAUTION
You may be exposed to hazards that could injure you when handling the
device and the spraying agents. You must therefore store the device and the spraying agents
out of the reach of children.
Empty and clean the device as in Chapter 7.1.
8

Problems with the device

Fault
Device is leaking at the
screw connection
Spray pattern of
nozzle not OK
Pump does not build
up any pressure
9 Disposal & Legislation
9.1 Environmental protection & disposal of the device >>
arated according to the different materials and disposed of at a recycling collection point. The
materials can be recycled according to their designations.
Please check with your local government to find the appropriate disposal point.
Empty the device before disposal and render it unusable.
9.2 Disposal of packaging >>
environment ally- suitable and disposal-related aspects and are therefore recyclable.
Returning the packaging to the material circulation saves raw materials and reduces the level of
waste. Please dispose of unwanted pack aging materials according to applicable local regulations.
figures
28 –
30
31
Cause
Hose loose
Nozzle partially blocked
Filter in quick closure valve
contaminated
O-ring on piston is
worn
The packaging materials have been selected according to
20 20
Remedy
Tighten coupling nut
and carry out pressure
test with water
Clean filter or nozzle
Replace O-ring
The device must be sep-