Warning Notices; Reasonably Foreseeable Misuse - Gloria 405T Mode D'emploi

1.2 Warning notices

WARNING
This level of warning notice indicates a potentially hazardous situation.
Follow the instructions accompanying this warning notice in order to avoid serious injury
or death.
CAUTION
This level of warning notice indicates a potentially hazardous situation
which, if not avoided, may result in serious injury.
Follow the instructions accompanying this warning notice in order to avoid serious injury.
ATTENTION
This level of warning notice indicates a potentially hazardous
situation which, if not avoided, may result in material damage. Follow the instructions
accompanying this warning notice in order to avoid material
NOTE!
A note indicates additional information or illustrations that help you
operate and facilitate the understanding of the device.
1.3 Intended use >>
of crafts and industry. Low-viscosity media, mineral oils, formwork oils and media in the PH range
≥ 5 and ≤ 9 may be sprayed.
Compliance with the accompanying instructions is a prerequisite for the proper use of the device.
The user manual also contains the operating, maintenance and servicing conditions.
Always comply with the safety instructions/safety measures of the spraying agent manufacturers
when applying spraying agents.
CAUTION!
Danger caused by improper use!
This device can be dangerous if not used for its intended purpose.
You should therefore observe the following safety instructions:
Use the device for its intended purpose only.
Note all instructions and information in the user manual.
1.4 Reasonably foreseeable misuse >>
The device is not suitable for group 1 fluids according to Directive
The device is also not suitable for:
Explosive, highly flammable or combustible liquids with a flash point below +60°C
-
- Oxidising or toxic media
- Acids (pH ≤ 5), alkalis (pH ≥ 9)
- Solvents or media containing solvents
- Fuels
- Wetting agents (surfactants) which may cause or promote cracks and fissures in the plastics
used
- Disinfectants and waterproofing agents as well as substances above 50°C
- Liquids that are highly viscous, sticky or form residues and cannot be fully emptied or rinsed
out of the device
- Use in the food sector
- Spraying pesticides
On request, the device manufacturer will provide a detailed material parts list of the device for
closer inspection.
The manufacturer does not accept liability for any damage or injury resulting from unauthorised
modifications to the device or its improper use.
This device is suitable for the application of spraying agents in the field
15
damage.
2014/68/EU
.