Using The Access Point Mode - Belkin F5D8633-4 Manuel De L'utilisateur

Using the Web-Based Advanced User Interface

Using the Access Point Mode

Note:
This advanced feature should be employed by advanced users
only. The Router can be configured to work as a wireless network
access point. Using this mode will defeat the NAT IP sharing feature
and DHCP server. In Access Point (AP) mode, the Router will need
to be configured with an IP address that is in the same subnet as
the rest of the network that you will bridge to. The default IP address
is 192.168.2.254 and subnet mask is 255.255.255.0. These can be
customized for your need.
1.
Enable the AP mode my selecting "Enable"
Access Point only" page. When you select this option, you will be
able to change the IP settings.
2.
Set your IP settings to match your network. Click "Apply
(2)
Changes"
3.
Connect a cable from the "Modem" port on the Router to your
existing network.
The Router is now acting as an access point. To access the Router's
Web-Based Advanced User Interface again, type the IP address
you specified into your browser's navigation bar. You can set the
encryption settings, MAC address filtering, SSID, and channel
normally.
.
(1)
(1)
in the "Use as
(2)
55 55
1
2
3
4
5
6
7
8
9
10