Belkin F5D8633-4 Manuel De L'utilisateur page 41

Alternate Setup Method
Setting your ISP Connection Type to Static IP (IPoA)
This connection type is also called "Classical IP over ATM" or "CLIP",
which your ISP provides a fixed IP for your Router to connect to the
Internet.
1. WAN IP Address
the Router WAN interface.
2. Subnet Mask
3. Use Static Default Gateway
If the Router cannot find the destination address within its
local network, it will forward the packets to the default gateway
assigned by your ISP.
4. VPI/VCI
- Enter your Virtual Path Identifier (VPI) and Virtual Circuit
Identifier (VCI) parameter here. These identifiers are assigned by
your ISP.
5. Encapsulation
Click "Apply Changes" to save and activate your settings. To go
back to the original settings before saving, click "Clear Changes".
Or click any of the Quick-Navigation links for other options. Your
new settings will not be saved unless your click "Apply Changes".
- Enter an IP address assigned by your ISP for
- Enter a subnet mask assigned by your ISP.
- Enter a default gateway IP address.
- Select LLC or VC MUX your ISP uses.
(1)
(2)
(3)
(4)
(5)
39 39
1
2
3
4
5
6
7
8
9
10