Publicité
Les langues disponibles
Les langues disponibles
Function
Indicator left
Trailer fog light
Earth
Indicator right
Tail light right
Stop light
Tail light left
Reversing light
Trailer current supply
Charge line plus
Charge line earth
Not assigned
Earth (trailer)
Push the socket with rubber retaining plate and screw the socket tightly onto the retaining plate using the supplied
5.
nuts and screws:
a)
Pay special attention to the right position of rubber retaining plate,
b)
Put the cable set gently to avoid any folds and to secure it from possible wiping.
6.
Lay the end of the cable strand with the yellow/green, blue/green, black/red, brown and grey/red wires to the
right taillight.
a)
Pull the vehicle-side 6-pole connector off the right hand taillight and join it to the matching piece of the
cable set. Push the remaining plug housing of the cable assembly onto the taillight.
7.
Lay the remaining cable strand with the 6-pole connector to the left taillight.
a)
Pull the vehicle-side 6-pole connector off the right hand taillight and join it to the matching piece of the
cable set. Push the remaining plug housing of the cable assembly onto the taillight.
8.
Lay the remaining end of the cable set with the 5-pin connection behind the left-side boot wall cladding.
a)
There, you will find three connectors. Disconnect the middle connector (function: rear fog light) and join the
open ends to the corresponding connectors of the cable set.
b)
Clip the two connections back into the existing recipient base.
Picture 2
1
1
2
2
3
3
4
1
2
3
4
Contact description
1
2
3
4
5
6
7
8
9
10
11
12
13
4
2
1
1
4
3
2
Cable colour
black/white
grey
brown
black/green
grey/red
black/red
grey/black
blue/red
2
red/blue 2,5mm
2
yellow 2,5mm
2
white/brown 2,5mm
2
white/brown 2,5mm
8
9
7
1
10
6
2
4
3
5
11
12
13
Contact description in
13-pin socket
Publicité
