Mitsubishi Electric PZ-62DR-E Manuel D'instructions page 38

3
Function setting
M-NET address
Function No.
Data
Function
Select:
Cursor
F1 F2
Function setting
M-NET address
Function No.
Data
Sending data
4
Function setting
M-NET address
Function No.
Data
Setting completed
Return:
F1 F2
3
32
2
Set / Conf
Address
F3 F4
3
32
2
3
32
2
F3 F4
Eng-38
The Function Setting screen will appear.
Press the or
one of the following: M-NET address, function
setting number, or setting value. Then, press
the or button to change the settings to the
desired settings.
Once the settings have been completed, press
the button.
A screen will appear that indicates that the
settings information is being sent.
To check the current settings of a given unit, enter
the setting for its M-NET address and function
setting number, select Conf for the Function, and
press the button.
A screen will appear that indicates that the settings
are being searched for. When the search is done,
the current settings will appear.
When the settings information has been sent, a
screen will appear that indicates its completion.
To make additional settings, press the
to return to the screen shown in Step 3 above.
Set the function numbers for other Lossnay units
by following the same steps.
Navigating through the screens
• To return to the Service Menu screen ......
• To return to the previous screen ..............
button to move the cursor to
button
button
button