Mitsubishi Electric PZ-62DR-E Manuel D'instructions page 5

To reduce the risk of injury and electric shock, avoid
contact with sharp edges of certain parts.
To avoid injury from broken glass, do not apply
excessive force on the glass parts.
Precautions for moving or repairing the controller
WARNING
The controller should be repaired or moved only by
qualified personnel. Do not disassemble or modify
the controller.
Improper installation or repair may cause injury,
electric shock, or fire.
Additional precautions
To avoid damage to the controller, use appropriate
tools to install, inspect, or repair the controller.
This controller is designed for exclusive use with
the Lossnay by Mitsubishi Electric. The use of this
controller for other systems or for other purposes
may cause malfunctions.
Do not pull or twist the communication cables.
Pulling or twisting a cable may result in fire or
equipment failure.
To reduce the risk of injury, wear protective gear
when working on the controller.
CAUTION
To reduce the risk of shorting, electric shock, fire,
or malfunction, do not touch the circuit board with
tools or with your hands, and do not allow dust to
accumulate on the circuit board.
To avoid discoloration, do not use benzene, thinner,
ethanol,hypochlorous acid or chemical rag to clean
the controller. To clean the controller, wipe with a
soft cloth soaked in water with mild detergent, wipe
off the detergent with a wet cloth, and wipe off water
with a dry cloth.
To avoid damage to the controller, provide protection
against static electricity.
Eng-5