Safety; General Safety Instructions; Instructions, Standards And Regulations; Safety Instructions - Stiebel Eltron SOL 23 Premium Utilisation Et Installation

.CZ`<<`.HC
Z%`t
.CZ`<<`.HC
7.

Safety

7.1

General safety instructions

We guarantee trouble-free function and operational reliability
only if the original accessories and spare parts intended for the
appliance are used.
Only qualified contractors should carry out installation, commis-
sioning, maintenance and repair.
7.2

Instructions, standards and regulations

Note
Observe all applicable national and regional regulations
and instructions.
7.3

Safety instructions

WARNING Burns
A solar collector generates heat when exposed to sun-
light or other types of light. This leads to collector con-
nectors getting very hot, even when they are not filled.
Risk of burns. Cover the collectors with opaque material
until they are actually installed. Only remove the collec-
tor packaging immediately prior to installation.
Damage to the appliance and environment
A solar collector generates heat when exposed to sunlight
or other types of light. This leads to collectors getting very
hot, even when they are not filled. The collector could
be damaged. Cover the collectors with opaque material
until they are actually installed. Only remove the collector
packaging immediately prior to installation.
Damage to the appliance and environment
Be careful not to drop the collector. Be careful not to
drop any objects on the collector. Do not step onto the
collector.
Damage to the appliance and environment
Do not leave the collector unsecured. If the collector falls
over, the glass may shatter.
qqq Z`. <é<`VHC HB
8.

Appliance description

This collector is specifically designed for on-end roof integration.
The laser-welded aluminium full area absorber has a highly selec-
tive vacuum coating (Miro-Therm). The hydraulic connection be-
tween collectors is made by means of a plug-in connector system.
A 3.2 mm thick safety glass cover (anti-reflex glass) protects the
absorber. The collector is insulated on the sides and back panel
with low outgassing mineral wool (black lined). The required ven-
tilation is carried out via two diagonal ventilation louvres in the
side profile of the collector. The collector casing is made from
saltwater-resistant aluminium. Operating the collectors with a
prepared water-glycol mixture (H-30 L) provides the essential frost
protection.
8.1

Standard delivery

4
1
2
7
1 Flat-plate collector
2 Lead flashing
3 Mounting bracket
4 Cover
5 Sealing strip
6 Tile lifter
7 Screws and nuts
- Cleaning cloth
8.2

Required accessories

T ® › T| 
Side flashing SOL AS 230184 Is used for integrating the collector into the
existing roof cover. The standard delivery
includes the plug-in connection for hydraulic
connection SOL SV R.
Plug-in connection 230187 Is used for the hydraulic connection of two
SOL SV-I collectors, incl. thermal insulation and air
vent screw.
Plug-in connection 230188 Is used for hydraulic connection and is only
SOL SV-R required if more than five collectors are in-
stalled next to each other.
Intermediate flash- 230183 Only for installation of collectors above each
ing SOL AZ other.
6
5
3
ùê›| ê
ZH< TVB.eB ’