Publicité
Les langues disponibles
Les langues disponibles
Opel Agila & Suzuki Wagon R
2000 - ....
Ref. 1252
Fitting instructions
1) Loosen the exhaust and remove the towing ring on the side. Also remove the floorcovering in the trunk.
2) Place mounting piece (-f) on the left side against the ground of the loading tray just beside the chassis beam.
Place the mounting piece as far as possible at the back (remove the betumen coating). Drill then the points
(E) through with a ø of 10,5 mm. Place now mounting piece (-i) in the trunk, insert the bolts and washers but
do not tighten yet.
3) Place now the tow bar so that point (A) matches with the existing drilling. Insert the heightened washer and
drill this point through unto the trunk with a ø of 10,5 mm. Point (B) must also be drilled through with a ø of
10,5 mm and must be enlarged on the upper side till a ø of 17 mm to enable to place the heightened washer.
Points (C) of the tow bar are matching with holes (C) of mounting piece (-f).Insert the bolts and washers.
4) Place mounting piece (-g) with point (D) against the towing ring in the middle of the vehicule and place (-h)
on the other side of the towing ring. Points (F) are matching on the drilling of the tow bar for the fixing of
(*). Insert all bolts and fasten up everything firmly.
5) Replace the exhaust and the floorcovering.
Composition
1 tow bar reference 1252
1 ball T43M000
2 bolts M12 x 40 + nuts
2 bolts M12 x 40
1 bolt M12 x 30 + nut
1 bolt M12 x 30
1 bolt M12 x 45 + nut
7 security washers M12
2 bolts M10 x 30 + nuts
2 bolts M10 x 80 + nuts
4 security washers M10
2 heightened washers
1 washer 50 x 50 x 12 x 2
1 mounting piece (-f)
Note
Please consult your cardealer or owners manual for the maximal permissable towing mass.
Remove any bitumen coating on the fastening position for the tow bar.
When drilling, be carefull not to damage any brake lines, electrical wiring or fuel lines.
(*)
(F)
(*)
(C')
(C)
(D)
(C-C'-D-F-*)
(E)
(A-B)
(A-B)
(A-B)
50 x 50 x 16 x 2/53
(A)
(E)
1 mounting piece (-i)
1 mounting piece (-g)
1 mounting piece (-h)
All bolts and nuts: quality 8.8
(E)
(D-F)
(D)
Publicité
