Publicité
Les langues disponibles
Les langues disponibles
Suzuki Ignis
2001 - ...
Ref. 1295
Fitting instructions
1)
Remove the inner coating and the spear wheel in the trunk. Disassemble the rear section of the exhaust
and also the 2 mud-flaps on the bumper.
Permanently remove the towing ring.
2)
Drill the 2 provided drillings in the underside of the chassis beam through till in the trunk with Ø10,5mm.
Place, in the trunk, the mounting plates (g) on the drillings and insert the bolts. Bring afterwards, through
the underside the tubes (i) in the chassis and place the tow bar so that the points (A) out of it are matching
with these bolts. Place washers and nuts but do not tighten yet.
3)
Place the mounting pieces (e) and (f) against the inside of the tow bar so that the points (C) of the tow bar
are matching with those of the mounting pieces. Insert the bolts, washers and nuts but do not tighten yet.
The points (B) of these mounting pieces are coming against the underside of the chassis beam, these
points through till in the trunk with Ø10,5mm. Enlarge this drilling in the trunk till Ø15mm
(DO NOT DRILL THROUGH!).
Bring the tubes (i) in the chassis and place the mounting plates (h) on these tubes. Insert the bolts, place
the washers and nuts an tighten everything firmly.
4)
Assemble (*) and also tighten firmly.
5)
Place everything from point 1 on its place.
Composition
1 tow bar reference 1295
1 ball T43L019
4nolts M12x40
4 security washers M12
4 bolts M10x80
10 security washers M10
10 nuts M10
4 mounting tubes (i)
2 mounting pieces (g)
2 mounting plates (h)
1 mounting piece (e)
1 mounting piece (f)
1 security shackle (800053)
6 bolts M10x35
Note
Please consult your cardealer or owners manual for the maximal permissable towing mass.
Remove any bitumen coating on the fastening position for the tow bar.
When drilling, be carefull not to damage any brake lines, electrical wiring or fuel lines.
(*)
(*)
(*)
(B-D)
(A-B-C-D)
(A-B-C-D)
(B-D)
(D)
(B)
(A-B-C)
(A-B-C)
(*)
(C)
All bolts and nuts: quality 8.8
Publicité
