Publicité
Les langues disponibles
Les langues disponibles
7.
Draw the remaining end of bunch with 6-connection joint to left parking lights:
a) Remove 6-input joint from rear lights and connect with the fitting joint in electric bunch, connect the remaining
joints of electric bundle to rear lights.
8.
Connect brown and white/brown cables to earth (for instance drill the 3mm hole and connect and fix the eyelet
terminal with sheet metal screw, do not secure the hole with anti-corrosion remedy):
9.
Connect the enclosed control module with 8-input joint to electric bunch and fasten next to spare wheel on the right
side of boot (with the attached M5x10 bolt) so that moisture protection is assured (danger of short circuit).
a)
Draw red module power supply lead through the left lead canal inside vehicle, near the right side of driver,
b)
Remove battery cover in the floor compartment. Connect red power supply lead with a loop ending to
positive pole of battery,
c)
Install fuse in base and connect both red power supply leads to empty joints in the fuse base.
10.
Trailer power supply:
3-pin connector housing (red/blue, yellow, and white/brown cables) is provided for expanded socket functions. Put
this part of cable set behind the trim. To expand socket functions it is necessary to order the following parts:
Function "current supply and earth"
Function "current supply, charge line and earth" part no. WYR991699R
Faulty operation of trailer's direction indicator is signalled by increased frequency of
Assembly instruction for the customer.
Secure the cable set with supplied cable ties, re-install all trims and other parts which were removed during
installation.
Connect the earth lead to the battery and check all vehicle functions with connected trailer or suitable testing
device.
part no. WYR990799R
Trailer lights control function
flickering of vehicle's indicators.
Publicité
