Closed System Connection - Dovre Sense 203GA 111 Installation Et Mode D'emploi

Connecting to the top
The stove is ready to be connected at the top upon
delivery.
When a pipe system from a manufacturer other
than Muelink & Grol is used, first use the
adapter belonging to that manufacturer's pipe
system.
Connecting to the back
1. First remove the baffle plate; see the following fig-
ure.
2. Remove the cast-iron collar by first removing the
two nuts on the inside of the appliance using a
13mm spanner. Lift up the collar so that the bolts
are exposed and turn them while you move the col-
lar upward. See the following figure.
13
3. Remove the inner collar by loosening the four bolts
with a 10mm spanner and then rotate the collar to
Subject to change because of technical improvements
13
4
09-20021-368
2
1
09-20021-366
the desired position (horizontally) and screw it
tight; see the following figure.
4. Mount the cast-iron collar and baffle plate.

Closed system connection

The concentric exhaust system allows for a series of
connection options for this appliance:
Through the facade, at any height, with or without
horizontal or oblique joint.
Through the roof, with or without horizontal or
oblique joint.
Through an existing flue gas exhaust pipe (chim-
ney)
First place the stove, see section "General pre-
paration". The concentric duct system can then be put
together in steps, starting at the stove.
Facade sleeve through a facade of
non-flammable material
Read the "Installation Conditions" chapter care-
fully and follow the installation instructions
below.
The following illustration shows the situation of a fin-
ished facade sleeve.
10
09-20021-367
9