bosal 033-801 Instructions De Montage page 17

The fact that the towing bracket has been mounted to the vehicle must be entered in the
vehicle papers at the next possible opportunity. The mounting instructions must be added to
the vehicle papers.
General Installation Intructions:
If present, remove insulating compound and/or underseal in the area of the towing bracket
contact surfaces. Coat bare bodywork with anti-corrosion paint.
Mount 7-pin electrical system as per DINV 72570.
Mount 13-pin electrical system as per ISO 11446.
Retighten all mounting bolts of the towing bracket after aprox. 1000 towing km. Please note,
that after mounting the drawbar the mass of your vehicle will change.
Mounting instructions:
According to drawing loosely fix the side plates (2,3) to the drag hook body (1) at
–
positions with the attached bonding units.
Slide the sides of the drag hook into the chassis beam, then according to drawing
–
the beam at „b" positions with the attached bonding units.
Adjust the drag hook into mid position, then tighten the bolts.
–
According to requirements carry out connecting of electric wires breaking the rear
–
of cables.
Only specialised services are authorised to install drawhooks.
–
„a"
fix it to
sheaf
17