bosal 011-458 Instructions De Montage page 4

Only for 13-pin socket sets. Put the 2-way connector from 12V socket on left side of the boot:
7.
a) Remove the housing from 12V socket and join with fitting connector from cable set,
b) Connect remaining connector from cable set to 12V socket.
8.
Bring the end of cable set marked R to the right tail lamp:
a) Disconnect 4-way side connector in vehicle and connect to fitting connector from cable set,
b) Connect remaining connector from cable set to right light connector.
9.
Lead the end of cable set with 5-way connector below the rear lights:
a) Disconnect the 5-way connector in vehicle (rear cover lights) and connect with fitting connector from cable set,
b) Connect remaining connector from cable set to another connector in vehicle.
10. Connect brown and white/brown cables (only in 13-pin sets) to earth (for instance drill the 3mm hole and connect
and fix the eyelet terminal with sheet metal screw; do not secure the hole with anti-corrosion remedy).
Secure the cable set with supplied cable ties, re-install all trims and other parts which were removed during instal-
lation.
Connect the earth lead to the battery and check all vehicle functions with connected trailer or suitable testing de-
vice.