Toro 29641 Manuel De L'utilisateur page 8

Figure 13
Mulching the Clippings
Your mower comes from the factory ready to mulch the
grass and leaf clippings back into the lawn.
If the grass bag is on the mower, remove it (refer to
Removing the Grass Bag) before mulching the clippings.
Bagging the Clippings
Use the grass bag when you want to collect grass and
leaf clippings from the lawn.
A worn grass bag could allow small stones
and other similar debris to be thrown in the
operator's or bystander's direction and result in
serious personal injury or death to the operator
or bystanders.
Check the grass bag frequently. If it is
damaged, install a new Toro replacement bag.
The blade is sharp; contacting the blade can
result in serious personal injury.
Stop the engine and wait for all moving parts to
stop before leaving the operating position.
Installing the Grass Bag
1. Lift up the rear deflector (Figure 14).
1. Rear deflector
2. Insert the grass bag handle onto the notches on the
handle brackets (Figure 14).
Removing the Grass Bag
1. Lift up the rear deflector (Figure 14).
2. Lift the grass bag handle out from the notches on the
handle brackets and remove the bag from the mower.
3. Close the rear deflector.
Discharging the Clippings
Use the rear-discharge deflector for cutting very tall
grass.
Installing the Rear-Discharge Deflector
1. If the bag is on the mower, remove it.
2. Lift up the rear deflector and hold it (Figure 15).
8
Figure 14
Figure 15