Toro 29641 Manuel De L'utilisateur page 7

Note: To raise the mower, move all the cutting height
levers forward; to lower the mower, move the all the
cutting height levers rearward (Figure 9).
1. Raise the mower
Note: The cutting height settings are 1 inch (25 mm);
1-1/2 inch (38 mm); 2 inches (51 mm); 2-1/2 inches
(64 mm); 3 inches (76 mm); 3-1/2 inches (89 mm); and
4 inches (102 mm).
Starting the Engine
1. Hold the blade control bar (Figure 10) against the
handle.
1. Blade control bar
2. Pull recoil start handle (Figure 11).
Figure 9
2. Lower the mower
Figure 10
Note: If the mower does not start after several
attempts, contact an Authorized Service Dealer.
Using the Self-propel Drive
To operate the self-propel drive, squeeze the self-propel
drive bar (Figure 12) toward the handle and hold it.
1. Self-propel drive bar
To disengage the self-propel drive, release the self-propel
drive bar.
Note: The maximum self-propel ground speed is fixed.
To reduce the ground speed, increase the space between
the self-propel drive bar and the handle.
Stopping the Engine
Service Interval: Before each use or daily
To stop the engine, release the blade control bar
(Figure 13).
Important: When you release the blade control
bar, both the engine and blade should stop within
3 seconds. If they do not stop properly, stop using
your mower immediately and contact an Authorized
Service Dealer.
7
Figure 11
Figure 12