Breville the YouBrew BDC600XL Livret D'instructions page 17

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

TROUBLESHOOTING
PROBLEM
POSSIBLE CAUSES
®
Machine takes a
The Brew IQ
long time to brew
intelligently pre-heat and
dose grinds for optimum
temperature and taste.
This may result in longer
grinding, pre-heating and
brewing times than what
you are normally used to.
®
Machine uses a lot
The Brew IQ
of coffee
has been calibrated to
dose the optimum water
to coffee grinds ratio to
achieve the best fl avor
profi le. Depending on the
strength setting selected,
this may result in more
coffee being ground than
what you are normally
used to. However the
result will be a bolder,
more full-fl avored coffee.
Amount brewed
There is excessive
is too little / too
mineral build-up affecting
much
the performance of the
machine.
The volume calibrations
need to be reset.
The water tank was fi lled
once the coffee machine
had already started a
brewing cycle.
The brew sizes are
approximate only. Actual
amounts may vary due
to the type of fi lter used,
the coffee bean size, roast,
blend and freshness,
or amount and type of
pre-ground coffee used.
These factors affect the
amount of water retained
by the coffee grounds.
32
WHAT TO DO
System will
If you would like to reduce the
overall brewing time and are using
SINGLE CUP mode, select a lower
fl avor setting. The 'LITE' setting will
steep for less time, however this will
produce a lighter fl avored coffee.
System
If you would like to use less coffee
beans, select a lower strength
setting.
De-scale the machine. Refer to
'Removing Calcium Build-Up',
page 27.
Recalibrate the machine by
fl ushing it twice. Refer to 'Using
the YouBrew
®
- Carafe Mode. First
Time Use Only', page 14.
Always fi ll the water tank before
starting a brewing cycle.
TROUBLESHOOTING
PROBLEM
POSSIBLE CAUSES
I cannot select
The minimum carafe
a certain carafe
amount is 2 cups, while
amount
the maximum is the
number of cups of water
in the tank, up to 12 cups.
I can only select
'INTENSE' strength
9 cups
setting selected. The
maximum number of
cups that can be brewed
at the maximum strength
is 9 cups.
My cup does not
The maximum cup or
fi t under the drip
travel mug dimensions
stop outlet.
are 7.5" height, 2¾"
diameter.
I regularly switch
beans
'DE-SCALE' on
There is excessive
LCD screen
mineral build-up affecting
the performance of the
machine.
I want to empty the
water tank
Water is leaking
Water tank is overfi lled.
from the back of
the machine
WHAT TO DO
Press open the fl ip-top water tank
lid. Pour the desired amount of cold,
preferably fi lter water.
To brew 12 cups, select the
'STRONG' strength setting.
Remove the drip tray at the base
of the machine. Press the OPEN
button to open the swing-out door.
Insert the cup/mug into the drip
tray cavity before closing the swing-
out door.
Buy an additional bean hopper to
make transfer and storage of beans
easier.
To grind out any residual coffee
beans, lock an empty bean hopper
onto the machine. Completely fi ll
the water tank, select '12 CUPS' and
the 'INTENSE' strength setting.
Press the START | CANCEL button.
When the grinder stops grinding,
press the START | CANCEL button
to cancel the cycle. Remove the
coffee grinds from the coffee basket.
Remove the 'DE-SCALE' icon by
pressing the SINGLE CUP and
CARAFE button together, then
de-scale the machine. Refer to
'Removing Calcium Build-Up',
page 27.
Refer to 'Empty the Water Tank',
page 27.
Do not exceed the 12 cup maximum.
The machine will beep when full
and the water level fl oat will rise to
indicate the maximum level.
33

Publicité

Chapitres

Table des Matières
loading

Ce manuel est également adapté pour:

The youbrew bdc600xl/a

Table des Matières