IMPORTANT INSTRUCTIONS
carpeting. Do not cover cord with
throw rugs, runners, or the like.
Arrange cord away from traffic area
and where it will not be tripped over.
⑭ Do not locate the heater
immediately below a fixed socket-
outlet.
⑮ To disconnect the fireplace, turn
the controls off, then remove the plug
from the outlet.
⑯
Means for disconnection must be
incorporated in the fixed wiring in
accordance with the wiring rules.
⑰ Do not insert or allow foreign
objects to enter any ventilation or
exhaust opening as this may cause
an electric shock or fire, or damage to
the heater.
⑱ Do not block air intake or exhaust
in any manner. Do not use on soft
surfaces, like a bed, where openings
may become blocked.
⑲ All electrical heaters have hot and
arcing or sparking parts inside. Do not
use in areas where gasoline, paint, or
flammable liquids are used or stored
or where the unit will be exposed to
flammable vapors.
⑳ Do not modify the electric
fireplace. Use it only as described
in this manual. Any other use not
recommended by the manufacturer
The heater carries the Warning Symbol
indicating that it must not be covered.
SAVE THESE INSTRUCTIONS
may cause fire, electric shock or
injury to persons.
㉑ Avoid the use of an extension
cord. Extension cords may overheat
and cause a risk of fire. If you must
use an extension cord, the cord must
be 3-core type and have a rating no
less than 13 Amps.
㉒ Do not burn wood or other
materials in the electric fireplace.
㉓ Do not strike the fireplace glass.
㉔ Always use a certified electrician
should new circuits or outlets be
required.
㉕ Always use properly grounded and
fused.
㉖ Disconnect all power supply
before performing any cleaning,
maintenance or relocation of the unit.
㉗ When transporting or storing the
unit and cord, keep in a dry place,
free from excessive vibration and
store so as to avoid damage.
CAUTION: In order to avoid a
hazard due to inadvertent resetting
of the thermal cut-out, this appliance
must not be supplied through an
external switching device, such as a
timer, or connected to a circuit that is
regularly switched on and off by the
utility.
5