Dimplex BLF5051 Manuel Du Propriétaire page 10

Fireplace Installation
• Remove the partially reflective
glass from the fireplace.
2. Locate the power cord and
remove the 3 screws that attach
the cord bracket to the unit - one
on the back of the unit and two on
the bottom. (Figure 5)
3. From the front, remove the 2
Philips screws that fasten the front
panel tabs, tilt the panel forward
and lift off. (Figure 4)
4. Remove the 4 screws that fasten
the acrylic media tray, and the 2
screws that attach the metal tray
to the unit.
The metal tray cannot be removed
but will now allow the ability to
remove the junction cover.
5. Remove the Phillips screw to
release the junction cover in the
bottom right corner of the fireplace
(Figure 6).
6. Carefully slide the junction cover
to the right to release the securing
tabs, as wires are fed through the
strain reliefs on the junction cover
and are connected within.
7. Unscrew the 3 wire connectors
under the junction cover and
separate the wires (Figure 7).
8. Pull the cord bracket and power
cord out the front of the fireplace.
9. Replace removed cord bracket
with the supplied hardwire bracket
replacement (Figure 8) and install
using screws removed in step 2.
10
Figure 4
Acrylic Tray screws (4)
Front Panel tabs (2)
Figure 5
Hardwire
Bracket
Figure 6
Junction Cover
Screw
Metal Tray
Screws (4)
Front Panel
Cord
Bracket
Screws
www.dimplex.com