Denon DJ MC7000 Guide D'utilisation Rapide page 4

Transitioning Between DJs
MC7000 has two USB ports, allowing you to control audio from two computers at the same
time, which allows for seamless transitions while switching from one DJ to another.
To transition between DJs:
1. While DJ 1 uses MC7000 normally, use a standard USB cable to connect DJ 2's computer
to the other USB port (1 or 2) on MC7000's rear panel.
2. While the master mix is playing audio from the left deck, set the right deck's USB selector
to DJ 2's USB port (1 or 2). (You can do this step with the master mix playing on the right
deck instead—just remember to swap "left" and "right" for the rest of this process.)
Now, while DJ 1 uses the left deck (and the mixer controls for Channels 1 & 3) to control
their computer, DJ 2 can also use the right deck (and the mixer controls for Channels 2 &
4) to control their computer.
Important: During this time, the Sampler Volume knob controls the volume level of the
sampler on both computers.
3. While the master mix is playing audio from the right deck (and after DJ 1 has played their
last track), set the left deck's USB selector to DJ 2's USB port (1 or 2).
Now, DJ 2 is using both left and right decks to control their computer.
Step 1
4
Step 2 Step 3