Denon DJ MC7000 Guide D'utilisation Rapide page 10

Rear Panel
3
2
1
1. Power Input: Use the included power adapter (5 VDC, 4 A, center-positive) to connect this
input to your power source.
2. Power Button: Press this button to power MC7000 on or off. Power on MC7000 only after
you have connected all of your input devices and before you power on your amplifiers and
loudspeakers. Power off your amplifiers and loudspeakers before powering off MC7000.
3. Cable Restraint: You can secure the power cable to this restraint to help prevent
disconnecting it accidentally.
4. USB Port 1/2: Use a standard USB cable (included) to connect each USB port to an
available USB port on a computer. These 2 ports allow you to control audio from 2
computers at the same time, which allows for seamless transitions while switching from
one DJ to another.
To set a channel to control your computer, set its input selector to USB, and set its USB
selector to the desired port (USB1 or USB2).
5. Master Outputs (XLR, balanced): Use standard XLR cables to connect these outputs to
loudspeakers or an amplifier system. Use the Master knob on the top panel to control the
volume level.
6. Master Outputs (RCA, unbalanced): Use standard RCA cables to connect these outputs
to loudspeakers or an amplifier system. Use the Master knob on the top panel to control
the volume level.
7. Stereo/Mono: Use this switch to set the channel configuration of the master outputs:
Stereo (binaural audio using separate left and right channels) or Mono (summed monaural
audio through both left and right channels).
8. Booth Outputs (XLR, balanced): Use standard XLR cables to connect these outputs to
booth monitors or a booth amplifier system. Use the Booth knob on the top panel to
control the volume level.
9. Line Inputs (RCA, unbalanced): Use standard RCA cables to connect these line-level
inputs to an external audio source.
10. Line/Phono Inputs (RCA, unbalanced): Use standard RCA cables to connect these line-
level or phono-level inputs to an external audio source.
11. Phono/Line Switch: Flip this switch to the appropriate position, depending on the device
connected to the Line/Phono Inputs. If you are using phono-level turntables, set this
switch to Phono to provide the additional amplification needed for phono-level signals. If
using a line-level device, such as a CD player or sampler, set this switch to Line.
12. Mic 1 Input (XLR or 1/4" / 6.35 mm): Use a standard XLR or 1/4" (6.35 mm) cable (not
included) to connect a standard dynamic microphone to this input. Use the Mic 1 Level
knob on the top panel to control the volume level.
13. Mic 2 Input (1/4" / 6.35 mm): Use a standard 1/4" (6.35 mm) cable (not included) to
connect a standard dynamic microphone to this input. Use the Mic 2 Level knob on the
top panel to control the volume level.
®
14. Kensington Lock: Use this slot to secure MC7000 to a table or other surface.
10
12 13
4 4
9
10 10
11 11
6
7
8 8 5 5
14