Publicité
GB
MoUNtING
1. Slide the 3-in-1 tap with the flexible hoses through the drilled hole.
2. Slide the gasket and retaining plate on to the threaded tube.
3. Tighten the locking spanner firmly.
4. Connect the flexible boiling water hose of the Itho 3-in-1 tap to the boiling water hose of the boiling water vessel.
Make sure to use the gasket between both boiling water hoses.
Connect the hot and cold water hoses with the mains pipes.
the picture illustrates these connections:
a. Cold water, (10mm compression fitting)
b. Hot water, (10mm compression fitting)
c. Boiling water, (connection M10 x 1,25 & gasket
caution: Place the gasket between the hose of the tap and the hose of the Heating Tank.
A spare gasket is supplied with the Heating Tank.
option: If necessary, install a filter valve on either side of the water filter for easy access and maintenance.
Filling and venting the heating tank.
1. Close the boiling water tap.
2. Open the mains valve.
3. Open the inlet valve of the pressure
relief valve.
4. Open the boiling water tap.
5. Wait until water flows from the tap.
6. Let the water flow for 3 minutes until
clear water flows from the tap.
7. Check for leaks, rectify as necessary.
Continue with the installation of the
Franke Heating Tank.
Voor de 10 L warmwatertank:
zie afzonderlijke handleiding.
Pour le chauffe-eau de 10 L:
voir manuel séparé.
For the 10 L heating tank:
see separate instructions.
1
2
3
4
b
a
c
13mm
c
Publicité
