Getting Started - Ribimex Ribitech PRKG110P Manuel D'instructions Et D'utilisation

IV. GETTING STARTED
4.1- Unpacking
Remove product from its packaging.
Check that it is not damaged.
4.2- Battery insertion and replacement (see fig.B)
Note: the batteries are not included.
1- Unscrew the battery compartment door.
2- Insert 2 batteries LR20 (D) type, respecting the polarity
3- Close battery compartment door.
4.3- Remarks on batteries:
- We recommend the use of alkaline batteries.
- Insert batteries by respecting the polarity.
- Change all batteries at the same time.
- Do not mix different types of piles (alkaline, saline...) or new and old batteries.
- Remove batteries from product when not in use for a long time, or during storage.
- Do not throw used batteries in household rubbish or in environment. Dispose of used batteries in designated
collecting centers.
V- OPERATION
5.1- Intended use
- This product is intended for household use indoors or under shelter.
- The product is designed for the transfer of liquids whose temperature is lower than 50°C: water, Diesel oil,
kerosene for auxiliary heaters.
5.2- Not intended use
The transfer of other liquids than those indicated above is not authorized, due to the following risks may arise (non
exhaustive list):
Liquids not authorized:
Petrol, leaded or unleaded gasoline
Detergents, Solvents, bleach
Highly Flammable liquids
Food liquids
Liquids with viscosity >10 cSt
Chemical or corrosive products
Fig.B
Potential hazards:
Fire / Explosion / Pump damage
Fire / Explosion / Pump damage
Fire / Explosion / Pump damage
Contamination of the liquid
Motor overload
Pump corrosion ; injury to persons
6