EUROM Fly Away Allround 16 Livret D'instructions page 15

4. The insect-killer can be suspended from the chain or placed on a surface such as
a table or cabinet. Make sure it is on a good stable base.
5. Install your insect-killer in a relatively dark place: not in direct sunlight
(windows, doors), because bright sunlight weakens the insect-killer's radiation
power. Artificial light does not weaken the radiation, but makes it work less well.
6. Do not place the insect killer in the draft. Insects avoid drafts / air
flows. Placing the insect killer in the draft flow will therefore not be
effective.
Use and Maintenance
Using
Make sure that the power socket you intend using is
earthed and the correct voltage (220-240V~50Hz).
Start the insect-killer working by plugging the device in
and then setting the ON/OFF switch (O/I) to ON (press
in 'I'). The insect-killer is operating. If desired,
attractants can be poured or laid in the appropriate
collection tray.
Service
For safety reasons, the user may not open the grille. So you may not replace
lamps, the fuse or the starter yourself: consult a certified electrician or other
qualified professional for this. The fuse and the starter of the Fly Away Allround
16/30/40 form a part of the circuit board, which can also only be replaced by a
qualified professional.
Cleaning
Regularly empty the collection tray by pulling it out of the appliance. Then empty
and clean it.
Dust and dirt influence the appliance's effectiveness, so regularly clean the
appliance. Switch the appliance off, remove the plug from the socket and remove
the collection tray. If you lay the appliance down, you can remove dust and dirt
from the appliance using e.g. a vacuum cleaner, a duster or a soft brush (not a
metal brush!). Never remove the grille! Do not use moisture or aggressive cleaning
15