Festo BWL-HSP Serie Guide Rapide page 17

1. Fit the support for the waiting position on the relevant
link side of the HSP−...
2. Fasten the support with two cheese−head screws 1
Replacing the cylinder
3. Push the cylinder upright, from above onto the
support.
4. When using the protective cover of the HSP−...:
position the pneumatic connections on the rear.
5. Fasten the cylinder with two cheese−head screws 2.
Please note
Make sure that the cylinder is fitted free of distortion.
S Observe the specified tightening torques.
S Tighten the screws equally in alternate sequence.
S After fitting, check manually to make sure that the
piston rod can be moved easily and smoothly.
Festo BWL−/BWR−HSP−... 0311NH English
type BWL−... left−hand side
type BWR−... right−hand side.
on the HSP−...−12 from above
on the HSP−...−16/25 at the side.
17