Publicité
Les langues disponibles
Les langues disponibles
V 4.1
OPERATION
1.
Do not drive fasteners near edge of material. The workpiece may split causing the
fastener or ricochet, injuring you or people around.
2.
Do not drive fasteners on top of other fasteners or with the tool at an overly steep
angle as this may cause deflection of fasteners which could cause injury.
3.
Do not actuate the tool unless you intend to drive a fastener into the workpiece.
4.
Always handle the tool with care:
a.
Respect the tool as a working implement.
b.
Never engage in horseplay.
c.
Keep others a safe distance from the tool while tool is in operation as accidental
actuation may occur, possibly causing injury.
AIR SUPPLY AND CONNECTIONS
1.
The connector on the tool must not hold pressure when air supply is disconnected. If
an incorrect fitting is used, the tool can remain charged with air after disconnecting
and thus will be able to drive a fastener even after the air line is disconnected, possibly
causing injury.
2.
Do not use any type of reactive gases, including, but not limited to, oxygen and
combustible gases, as a power source. Use filtered, lubricated, regulated compressed
air only. Use of a reactive gas instead of compressed air may cause the tool to explode
which will cause death or serious personal injury.
3.
Use only a pressure-regulated compressed air source to limit the air pressure supplied
to the tool. The regulated pressure must not exceed 100 psi. If the regulator fails, the
pressure delivered to the tool must not exceed 200 psi. The tool could explode which
will cause death or serious personal injury.
4.
Always disconnect air resource:
a.
Before unloading or making adjustments.
b.
When maintaining the tool.
c.
When clearing a jam.
d.
When touching the safety yoke.
e.
When tool is not in use.
f.
When moving to a different work area.
Such precautionary measures reduce the risk of injury to persons.
LOADING TOOL
1.
Do not load the tool with fasteners when any one of the operating controls
is activated.
2.
Never place a hand or any part of body in fastener discharge area of tool.
3.
Never point tool at anyone.
WARNING: The warnings and precautions discussed above cannot cover all possible conditions
and situations that may occur. It must be understood by the user that common sense and
caution are factors which cannot be built into this product, but must be supplied by the user.
6
2-in-1 Flooring Nailer and Stapler
For technical questions call 1-800-665-8685
8558777
Publicité
