Publicité
Les langues disponibles
Les langues disponibles
8558777
LOADING STAPLES
1.
Pull the Outer Magazine (A) back to
the end of magazine.
2.
Place a full clip of 1/2 in. Crown
Staples (C) in the magazine from the
top. Up to 90 pcs can be loaded into
the tool. (Fig. 2)
3.
Push the Outer Magazine (A)
forward until to the pop-up
lock position.
WARNING: The tool may fire when it
first connected to the air source. Always
connect the tool to the air source before
loading fasteners to prevent injury from
unintended cycling. Always make sure the
tool's magazine is empty at the beginning of
each work session, before connecting to an
air source.
CHANGE THE FOOT PLATE
The tool is equipped with a factory pre-
installed 3/4 in. foot plate(D).
And an additional uninstalled 5/8 in. foot plate.
To change the plate:
1.
Disconnect the tool from the
air source.
2.
Empty the magazine completely.
3.
Fire the tool into a piece of scrap
wood to ensure there is no
compressed air or fasteners left in
the tool.
4.
Set the tool on its side to expose the
three screws(E).
5.
Remove the three screws(E), then remove the foot plate.
6.
Align the three screw holes in the replacement foot plate with the three threaded
mounting holes.
7.
Using the three screws you removed just now, secure the replacement foot plate to
the tool.
8.
Ensure the correct Foot Plate is installed by firing into a scrap piece of flooring and
checking for proper fastener placement.
WARNING: Disconnect the tool from the air source whenever changing the foot plate. Make
sure there is no fastener in the magazine before changing the foot plate.
Visit www.princessauto.com for more information
2-in-1 Flooring Nailer and Stapler
FIG. 1
FIG. 2
FIG. 7
Foot Plate(D)
Screws (E)
Outer Magazine (A)
L Cleat (B)
Outer Magazine (A)
Staples (C)
V 4.1
9
Publicité
