Power Fist 8558777 Manuel De L'utilisateur page 14

V 4.1
TROUBLESHOOTING
WARNING: Stop using tool immediately if any of the following problems occur. Serious
personal injury could result. Any repairs or replacements must be done by a qualified
service person or an authorized service center.
PROBLEMS
Air leaking in
head cap.
Lack of power.
Slow to cycle.
Not shooting
fasteners.
Fasteners are jammed
in the tool frequently.
WARNING: Use only identical replacement parts. For questions please call 1-800-665-8685
or visit our website at www.princessauto.com.
WEARING PARTS
Repair parts can be ordered from our website: www.princessauto.com or by calling
1-800-665-8685.
14
2-in-1 Flooring Nailer and Stapler
POSSIBLE CAUSE(S)
1. Loose screws.
2. Worn or damaged O-rings
or seals.
1. Tool is too dry.
2. Air pressure too low.
3. Exhaust blocked.
1. Damaged pusher spring.
2. Wrong size of fasteners.
1. Drive channel is worn.
2. Piston is broken or worn.
3. Bent fasteners.
4. Dirty magazine.
5. Loose magazine.
6. Wrong fasteners.
CORRECTIVE ACTION
1. Tighten screws.
2. Install overhaul kit.
1. Add about 2-3 drops
of lubrication into the
air connector.
2. Make sure the air compressor
is set between 70 psi and
110 psi.
3. Clean exhaust channel.
1. Replace spring.
2. Use 1/2 in. crown staples or
1-1/2 in. to 2 in. nails.
1. Fix the drive channel.
2. Replace the piston.
3. Remove the bent fasteners,
replace with the 1/2 in. crown
staples or 1-1/2 in. to 2 in. nails.
4. Clean magazine.
5. Tighten screws.
6. Verify that fasteners are the
correct size.
For technical questions call 1-800-665-8685
8558777